With two spoons, work the tire back and
forth, walking the tire over the rim lock.
Using two tire irons about 4 inches
apart, push down and insert your Bead
Buddy tool to keep the tire down off the
bead. I like to keep this about 2 inches
from the valve stem.
Remove your Bead Buddy with a slight
pry on the tire. Set your tire pressure
between 12 and 14 pounds for most use.
Install your cap so that it stops against
the valve-stem nut. Don’t tighten the
nut down to the rim, as this can cause
it to rip off if the tire turns. Tighten the
rim lock nut; however, be careful of
over-tightening, as you can damage the
rim. Now, go ride! o